Production of fuel tanks

Manufacturer of all types of fuel tank

Metal fuel tanks are made of stretching metal sheets in the upper and lower halves, which are connected by welding spools. Of course, in heavy vehicles and metal tanks higher than 100 liters, the production method is usually "bending the sheet and welding its joints

metal fuel tanks sheets are usually high-grade tensile steel so that it can be stretched to the desired depth and shape. The main issue in metal fuel tanks is the problem of corrosion, which is directly related to the type of sheet coating used, which is galvanized sheets in Mobin Ghateh Asia Co

Then the tension is applied on it. In this case, the corrosion resistance is reduced, which can be validated by testing the salt spray (placement in salt) at the standard time

and has a different shape, material and location in the vehicle, depending on the type of vehicle, both light and heavy

A fuel tank is a tank that holds fuel, including gasoline, diesel, and gas, and pumps it when the engine needs it

A fuel tank is a tank that holds fuel, including gasoline, diesel, and gas, and pumps it when the engine needs it. One of the safety issues in the tank is that the most important part that determines the type of design of the tank should be such that the vapors from the fuel can be evacuated because failure to evacuate it will cause an explosion and endanger the safety of the occupants

located in the lower part of the chassis and under the rear seats, and this is because in the event of an accident that occurs from the rear of the car, the tank is protected and the tank is not damaged, and ultimately the safety of the occupants is maintained

:Material

The important point about car tanks is to pay attention to their material, which is available in two types of polymer and metal, which are generally semi-heavy and heavy metal car tanks and light polymer cars, which use both types of unique standards. For example, in metal tanks, there must be galvanized sheet to protect the tank from corrosion, and in the case of polymer, it must be such that the ingredients do not react with the fuel inside and are not saturated

Of course, in order to confirm the suitability of the material and type of tank cover, which is especially important in metal tanks produced by Mobin Ghateh Asia Company, various tests are performed, including corrosion resistance, salt spray test and galvanized plating, vibration test, resistance to Equal to impact and paint adhesion

:How does fuel tank work

The tank in the car is very important, whether the car tank is made of plastic or metal, the fuel pump may be installed inside or outside it, but the fuel pump is usually placed inside the tank. In general, in all these cases, the fuel is transferred from the outside environment into the tank and is directed to the engine by a pump. The same fuel, regardless of its type, is mixed with air in the engine and burns the car. What kind of tank it is, where it is located in the car and how the fuel pump is connected to it all depends on the type of car and its design. In Mobin Ghateh Asia Company, a set of gauges and gas and diesel fuel tank pumps is produced and installed on the produced tank and presented to Zamyad Company

:Warranty

The guarantee, commitment and acceptance of Mobin Ghateh Asia Company based on the correct operation of the tank in a certain period of 24 months is a kind of guarantee of design, mechanism of parts and assembly. In case of any problems during this period, all the defects caused by the production will be fixed by the company as free

(24 months warranty on all types of Nissan tanks produced by Mobin Ghateh Asia Company)

:The reason for the gas leak from the car tank

Fuel transmission pipe failure

Buck compartment damage

Lack of tight lid

Injector failure